Skip to content
Have Questions? Call us at 281-334-0766 or Toll Free 888-777-7213
STI Vibration Monitoring Inc.
STI Main Office
Motor Fin Mounts
Proximity Probe Mounting
BNC Junction Boxes
Low Cost (Indoor)
Transmitters and Monitors
4-20 mA Sensors
CMCP793V-500 Piezo-Velocity, Top Exit
Add Mounting Pad?
[No Pad] No Pad
[With Pad] Add Pad [Add $6.00]
CMCP793V-500 Piezoelectric Velocity Sensor
measurement devices which is used to examine vibration signals in terms of velocity (in/sec) to amplify the signal of interest. The CMCP793V-500 inherently decreases high frequency signals allowing better measurement of low frequency vibration. The CMCP793V-500 sensor is essentially an accelerometer with an internal integration circuit which will produce an output relative to velocity. The CMCP793V-500 is the ideal accelerometer for on most types of rotating equipment. The CMCP793V-500 is lightweight and can be use for magnet or permanent mount applications. The sensor is designed so that cross wiring will not harm the internal components and provides protection against ground loops. The CMCP793V-500 is waterproof and can be hosed down or submersed when using the proper extension cable such as the CMCP602 series.
Sensitivity: 500mV/in/sec ±10%
Frequency Response (±3dB): 2Hz to 6kHz (120 to 260k CPM)
Dyanamic Range: ±10 In/Sec
Power Requirements: 18-30 VDC
Temperature Range: -67 to 284°F (-55 to 140°C)
Case Material: 316L Stainless Steel
Connector: 2 Pin MIL-C-5015
Approvals: CSA/UL Class I Division II Approved, Groups B, C,D
Accessories for this product...
CMCP205 Accelerometer Motor Fin Mounts
CMCP210 Acrylic Adhesive Bypacs For Accelerometer Mounting
CMCP200 Accelerometer Mounting Pads
CMCP203 NPT Pipe Thread Accelerometer Mounting Adapter
CMCP602L General Purpose TEP 2-Pin Accelerometer Cables
Browse for more products in the same category as this item: