Home > Transmitters and Monitors > TSI Functions >

CMCP548 Case Expansion Transmitter/Monitor for LVDT's
Case Expansion Transmitter/Monitor


 
CMCP548 Data Sheet
US MSRP: $670.00


Product Code: CMCP548

Alarm Module

  

Description Technical Specs
 

CMCP500 Transmitter Approval Label

  • DC LVDT Input
  • Case Expansion Out
  • Transmitter or Monitor
  • DC Detection
  • Towards/Away Selectable
  • Up to 2" Range
  • 4-20 mA Output
  • 2 Buffered Outputs
  • Fault (OK) Detection
  • DIN Rail Mount

The CMCP548A Case Expansion Transmitter are compatible with 10mV/mil LVDT inputs, they provide a 4-20 mA output proportional to the overall measurement. Each unit provides power for the associated transducer, processes the signal, and outputs a 4-20 mA dc current that is proportional to a user specified range such as 0-2 inches. Combining monitors with an existing PLC or DCS system results in a high density, low cost vibration monitoring system.

With the alarm option, the unit functions as a complete single channel monitor that includes alert and danger alarms, and output relays.

Alarms relays and trip multiply are available with the Monitor version.

CMCP500 Monitor Approval LabelAlarms - The CMCP500A Series Monitors have two independent set points, with LED alarm indicators and output relay contacts (Alert and Danger). Set points are adjustable via potentiometer, from 0 to 110% of full scale. Each has an adjustable delay of 1 to 10 seconds. SPST Relay contacts are rated 5 Amps @ 30 Vdc or 250 Vac for resistive loads.

Relay contacts can be independently configured by the user for either Normally Open (NO) (Standard) or Normally Closed (NC) operation. Relays are normally de-energized and can be configured for latching or non-latching (standard) operation. Latched alarms may be reset locally or by remote contact closure.

Trip Multiply - The monitors have set point multiplication of 3X via contact closure (2X available). To avoid tripping the alarms during machine start-up.

Custom Input and Output Configurations Available Upon Request

Buffered Output:

A BNC connector mounted on the front of the unit provides access to the buffered transducer output signal. This includes both the unfiltered vibration signal, and the DC bias voltage. Portable test equipment or analyzers like SKF-CM's MicrologTM can be connected to this output without disturbing other system outputs.

Fault Detection:

On board fault detection circuitry continuously monitors the transducer for normal operation. If a fault occurs, the output current is reduced to 2 mA to indicate the fault to the readout system. A red LED on the front of the unit is turned on to provide a local indication of the fault.

Optional Alarms:

This monitoring option adds two independent set points, with LED alarm indicators and output relay contacts (Alert and Danger). Set points are adjustable via potentiometer, from 0 to 110% of full scale. Each has an adjustable delay of 1 to 10 seconds. Relay contacts can be independently configured by the user for either Normally Open (NO) (Standard) or Normally Closed (NC) operation. Relays are normally de-energized and can be configured for latching or non-latching (standard) operation. Latched alarms may be reset locally or by remote contact closure. SPST Relay contacts are rated 5 Amps @ 30 Vdc or 250 Vac for resistive loads. The Alarm option also provides set point multiplication of 3X via contact closure (2X available).

Documents Available:

CMCP548 Data Sheet CMCP548 UL/CSA Certificate CMCP548 CE Certificate


Browse for more products in the same category as this item:

Transmitters and Monitors > TSI Functions