CMCP270 Piloted End Mill Spot Reamer

     Features:

• Ideal for accelerometer mounting
• Provides a smooth surface perpendicular to mounting hole
• Disposable and low cost
  

Piloted End Mill Aircraft Spot Reamers are used to mill a 1" (2.54 cm) smooth flat area on bearing housings. The flat area will accept a stud mounted accelerometer or a glue (epoxy) mounted with an STI Accelerometer Mounting Pad. A 7/32" drill,  pilot, allen wrench and end mill are included in each kit. The 7/32" drilled hole can then be tapped with a 1/4" x 28 UNF starter and bottom tap for stud mounted accelerometers.

CMCP270

Piloted End Mill Spot Reamer

1/4-28 Kit

M8 Kit

M6 Kit