|
| |
|
CMCP-560
Isolated RTD Temperature Transmitters |
|
 |
Features:
-
Low Cost
-
Small Size
-
DIN Rail Mount
RTD
Input
4-20 mA Output
Fault Detection
Buffered Transducer Output
Filter Option
Approved |
Temperature Transmitter Data
Sheet in PDF Format
Description:
The CMCP560 Isolated RTD Temperature Transmitters are compatible with
RTD inputs, and they provide a 4-20 mA output proportional to the
overall measurement. Each unit provides power for the associated
transducer, processes the signal to determine overall amplitude,
and outputs a 4-20 mA dc current that is proportional to a user specified
range such as 0-250 Deg, F. Combining transmitters with an
existing PLC or DCS system results in a high density, low cost monitoring system.
Buffered Output:
A BNC connector mounted on the front
of the unit provides access to the buffered transducer output signal. This
includes both the unfiltered vibration signal, and the DC bias voltage.
Portable test equipment or analyzers like SKF-CM's
MicrologTM can be connected to this output without disturbing
other system outputs.
Fault Detection:
On board fault detection circuitry
continuously monitors the transducer for normal operation. If a fault
occurs, the output current is reduced to 2 mA to indicate the fault to the
readout system. A red LED on the front of the unit is turned on to provide a
local indication of the fault.
Alarms:
The CMCP560 Isolated RTD Temperature Transmitters do
not have any alarm features. For alarms we have the CMCP560A
Isolated RTD Temperature Monitors
Displays And Assemblies:
Various display options, NEMA
and explosion-proof enclosures, and assembled multi-channel systems are
available. Consult your sales representative.
Electrical Specifications:
Power: +24 Vdc @ 45 mA max.
(30 mA typical at 2
full scale output). Reverse polarity and transient protection
included.(With the Alarm/Relay option installed: 75 mA max.)
Frequency Response (Without optional filters): (-3 dB) 2 Hz to 20
kHz.
Buffered Output: BNC Connector 0-20 kHz.
Accuracy: 5.0 % of Full Scale Range.
Output: 4-20 mA proportional to the full scale range.
Maximum Load: 600 Ohms Resistive.
Case: Isolated.
Environmental Specifications:
Operating Temp.: -20oC to +80oC
(-4oF to +176oF).
Storage Temp.: -55oC to +125oC (-67oF
to +257oF).
Relative Humidity: 0 - 95% Non-Condensing.
Mounting:
32 mm (G style) or 35 mm (T style) DIN Rail.
Ordering Example:
To order a isolated
RTD temperature transmitter that accepts input from a 100 Ohm Platinum RTD, with a Full Scale of
0-250 Deg. F detection,
specify Part Number: CMCP560-100P-01.
NOTES:
1.The Full Scale option
specified at order entry is used by the factory for initial calibration.
However, several other ranges can be jumper selected in the field.
2 .Transducer
and Full Scale options not listed in the above table are available.
Contact your sales representative.
CMCP560
Isolated
RTD Temperature Transmitter
CMCP560-(aaaa)-(bb)
(aaaa) Input
100P, 100 Ohm Platinum RTD
(bb) Full Scale
01, 0-250 oF
02, 0-350 oF
03, 0-500 oF
51, 0-120 o C
52, 0-175
oC
53, 0-260
oC
|
|
