Threaded and
slotted to insure position and stability
Mounting Brackets are used when installing eddy probes (proximity probes)
internally in the machine. They may be mounted directly to the side of
radial bearings using two (2) 10-32 Cap Screws. The brackets are 1/2" High
x 1" Wide x 1" Deep (12.7 x 25.4 x 25.4 mm). The eddy probe mounting hole is
offset 3/4" or 1/4" (19.05 or 6.35 mm) depending on the mounting direction of
the block relative to the bearing. Tightening the mounting bolts applies a positive lock
to the eddy probe preventing movement of the probe after mounting. These mounting blocks
are available for 1/4"-28 UNF, 3/8"-24 UNF probe body
threads. Since these mounting blocks are manufactured from Aluminum, they may be easily
machined in the field as required during installation.
