Skip to content
Have Questions? Call us at 281-334-0766 or Toll Free 888-777-7213
STI Vibration Monitoring Inc.
STI Main Office
Motor Fin Mounts
Proximity Probe Mounting
BNC Junction Boxes
Low Cost (Indoor)
Transmitters and Monitors
4-20 mA Sensors
CMCP212 Silicone Dielectric For Accelerometer Mounting
Hazardous Material Shipping Added
[Ground] Standard Ground Shipping
[Fedex] Air Delivery (Federal Express Only) [Add $60.00]
In high frequency accelerometer applications, it is recommended by the manufacturer to apply a thin coating of Silicone Dielectric between the accelerometer and the mounting surface before mounting the accelerometer to the proper torque. The dielectric helps insure the transmittal of high frequency vibration across the mounting interface. When an accelerometer is installed in harsh or moist environments, Silicone Dielectric is also recommended for additional sealing of the accelerometer's connector. Each one (1) ounce tube of Silicone Dielectric will install approximately 50 to 100 accelerometers. When also used as a connector sealant, each tube will install approximately 15 to 25 accelerometers.
Browse for more products in the same category as this item: