CMCP210 Acrylic Adhesive Bypacs

Acrylic Adhesive Bypacs are an easy to use solution for gluing Accelerometer Mounting Pads to a prepared surface area on the bearing housing. The adhesive is prepared inside the Bypac by removing the plastic separator and kneading together the two adhesive components. A corner of the bag is then removed to allow easy dispensing of the mixture. Each Bypac will glue one (1) Accelerometer Mounting Pad. A Material Safety Data Sheet for this product can be supplied on request.

• Non-Sag - remains non-sag when applied on vertical surfaces
• Exceptional Cold Temperature Strength - performs at temperatures from -40°C to 149°C (-40°F to 300°F)
• Bonds Unprepared Metal - requires little or no substrate preparation
• Bonds Plastic - bonds difficult plastics such as polycarbonate and XENOY
• Excellent Environmental Resistance - resists dilute acids, alkalis, solvents, greases, oils, moisture, and weathering. This adhesive also provides excellent UV exposure resistance.

CMCP210 acrylic adhesive bonds a wide variety of prepared or unprepared metals and engineered plastics. CMCP210 adhesive is specifically formulated to provide the highest impact and peel strengths available in a room temperature curing adhesive. CMCP210 adhesive replaces welding, brazing, riveting and other mechanical fastening methods especially in low temperature environments subject to high impact or high peel loads.

Note: This item is classified as a Hazardous Material. For all shipment methods other than UPS Ground, there will be a $75.00 HazMat Handling Fee added at the time of shipment. This fee covers the required shipping container and all necessary paperwork.

Instructions:

• Surface Preparation
  Remove grease, loose contamination or poorly adhering oxides from metal surfaces. Normal amounts of mill oils and drawing compounds usually do not present a problem in adhesion. Most plastics require a simple cleaning before bonding. Some may require abrading for best performance.

• Mixing
  Hand mix or apply with automatic meter/mix/dispense equipment. Mix resin with the proper amount of accelerator. Once mixed, the acrylic adhesive cures rapidly.

• Application
  Apply to substrates and join.

• Curing
  The cure is completed in 24 hours at room temperature. The cure rate can be accelerated by applying modest heat. The surfaces need to be held in contact during the entire cure period. If heat cured, do not exceed temperatures of 66°C, 150°F.

• Clean Up
  Uncured Adhesive - Clean excess adhesive on the bonded assembly, as well as mixing and application equipment, before the adhesive cures. Use hot water and detergent, or an organic solvent.
  Cured Adhesive - Heat the cured adhesive to 204°C (400°F) or above to soften the adhesive.

Acrylic Adhesive

Accelerator

Appearance

Off-White to Tan

Off-White

Viscosity, cps Brookfield at 25°C

100,000 - 300,000

10,000 - 100,000

Density

   Kgs/m³

1097 - 1162

1150 - 1246

   lbs/gal

9.1 - 9.7

9.6 - 10.4

Flash Point

15°C (59°F)

>93°C (>200°F)

Mix Ratio

   By weight

10

1

   By volume

10

1

Working Time @ 24°C (75°F)

6 - 10 minutes

N/A

Handleable Bonds @ 24°C (75°F)

12 - 17 minutes

N/A

Shelf Life from date of shipment, @ 24°C (75°F), unopened container

6 Months

6 Months

CMCP210

Acrylic Adhesive Bypac